Every hard set of 1 to 12 reps becomes an estimated one-rep max, and every session with a counted set becomes one point on the trend — the highest estimate that session produced. That lets you watch strength move without testing a true single. The estimate averages two formulas; warm-ups and higher-rep sets never move the line. Read the direction, not any single dot.

The formulas below are established strength-estimation equations; how Kaltro averages and caps them are our design choices. For the plain-English definition, see what an e1RM is, or try the e1RM calculator to watch the numbers move.

What one trend point is

One session, one point. Kaltro estimates a one-rep max for every working set that counts in that session and plots the highest of them. A session in which no set counted adds no point at all — a gap in the line, not a low dot.

  • Kaltro averages two formulas — Epley (weight × (1 + reps ÷ 30)) and Brzycki (weight × 36 ÷ (37 − reps)) — and runs them on every counted set in the session.
  • The session’s highest estimate becomes the point, which is not always the heaviest set you lifted. On the formulas above, 100 kg × 10 estimates 133.3 kg and 120 kg × 3 estimates 129.5 kg — so on that day the 10-rep set is the one that gets plotted.
  • A true single is taken at face value: a 1-rep set’s estimate is the weight you lifted, rather than a calculated one.

Both formulas are well-established for low-to-moderate reps, which is exactly where Kaltro keeps them (LeSuer et al., 1997).

Taking the session’s highest estimate, rather than its average, is our choice. Under an average, every set that estimated lower than your best would pull the point down, so your trend would partly track how much back-off work you did that day instead of what you could lift. Taking the highest estimate means no extra set can pull a point down — only raise it.

Only 1-to-12-rep sets can move the line

Only a set between 1 and 12 reps can become a session’s trend point. A set above 12 reps is never estimated for the trend, so it cannot push the line up or down.

These equations lose accuracy as the reps climb — the further a set is from a true single, the further either formula can land from a measured max (Reynolds et al., 2006). Cutting the trend off at 12 reps is our line in the sand: informed by that drift, chosen by us, and tunable.

Your e1RM personal record uses this same averaged estimate and the same 1-to-12-rep limit.

Warm-ups and drop sets never appear

The trend is built from real working effort only.

Completed working sets feed the line; warm-ups and drop sets are excluded, the same way they are kept out of the evidence Kaltro needs before a suggestion. That keeps a light warm-up single from ever masquerading as a strength gain.

Read the trend, not the dots

An e1RM is a direction, not a target.

  • It is an estimate for tracking, never a number to attempt. Prediction equations carry real error, so an estimated single is a signal of progress, not a cue to load the bar and test it. Kaltro never suggests testing an estimated max.
  • One low dot is not evidence of a loss. These equations assume a set taken close to failure, so a session where you left reps in reserve estimates lower — they carry no term for reps you had left (LeSuer et al., 1997). Reps in reserve are also harder to judge as the reps climb (Zourdos et al., 2016; Hackett et al., 2017), and strength varies between sessions.
  • A dot can also sit low because your hardest work never counted — above 12 reps, logged as a warm-up, or not completed — which leaves a lighter set as the session’s highest estimate. The slope over weeks tells the real story.
  • Lighter work added later cannot pull a dot down. Only the highest estimate from a session is plotted, so a back-off set can raise a point or leave it where it is — never lower it.

Watch your strength trend build itself

Log your working sets and Kaltro charts the averaged e1RM automatically, workout by workout — the same math this page describes, from your own logged sets.

Keep reading: how Kaltro decides when to add weight, when it calls a deload, and how much history it needs first. Terms and tools: e1RM, personal record, and the e1RM calculator. In the app, the trend and your PRs sit together — see strength progress in Kaltro.

The research behind this

  • LeSuer et al. (1997). Journal of Strength and Conditioning Research.
  • Reynolds et al. (2006). Journal of Strength and Conditioning Research.
  • Zourdos et al. (2016). Journal of Strength and Conditioning Research.
  • Hackett et al. (2017). Journal of Strength and Conditioning Research.